2.15.1.12 another strange sequence startup logic

Sequence Generator
1

I think I found another one of those anomalies that has crept in .

  • Load sequence, connect to all.
  • In target settings, ‘slew to’ at target start is already enabled
  • Put in start capturing time (time in past, by mistake)
  • Hit OK

Ran sequence, - sequence started up immediately, tried to start up PHD2, but did not slew to target first.

2

Right. I believe this falls into the category of things the fix in 2.5.1.13 fixes.

3

Thanks Ken. Knowing how it is currently working, I disconnected, hit run and I had another 4 hours of acquisition, including meridian flips and park/close at the end of operations.
I’ll do another video sometime soon that shows how to do the initial setup etc