Hello Ken & Jared,
I have just installed the new beta, v.22.214.171.124, and immediately noticed that it wasn’t communicating properly with PHD2 when I connected all equipment. I discovered that the PHD2 port number needed to be set to 4400 in the equipment panel and all works perfectly now. Just wondering why the default PHD2 port number is set to 1025 and not 4400?
I look forward to giving this beta a good workout.
One thing that has been on my mind is the camera cooler behaviour in conjunction with the restart on safe functionality. Currently it will warm up the CCD on Unsafe shutdown and then cool down again on safe restart, with appropriate delays to wait for those warm and cool cycles to complete. I would prefer the functionality to be that the cooler is left on when there is an unsafe event shutdown, so that there is no warm / cool cycle delay before restart on safe. The CCD warm up should only happen when the sequence completes - either when all events are completed or the sequence end time occurs. The sequence should react to the sequence end time when waiting to restart on safe too. I hope that all makes sense and is easily possible to add / change.