Allow for both "cool down on camera connect" and "cool down on sequence start"

currently these two choices are mutually exclusive, but it’s easy to get into a situation where the camera cooler is off when a sequence starts (like if you have "cool down on connect set, then ran a sequence which completed, which then shut the cooler off, but then rejiggered the sequence and started up again.)

i assume that making these two checkboxes non-exclusive would solve this problem, though maybe not (there seems to be a distinction between starting a sequence and resuming a sequence - i’d like SGP to check the cooler state and start the cooler if off in the resume and start cases.)

thanks

rob