Alternatives to "Abort" when Auto Center Validation Frame Fails?

Hello! Just curious. When I have multiple photometry targets, occasionally, one target in the sequence will fail to Autocenter with PinPoint and Astrometry.Net rollover. Currently, SGPro aborts when Autocenter fails. I would prefer the sequence to continue on to the next target in the sequence.
Is there an alternative to sequence abort when Autocenter fails? I could not find anything about this in the manual. Thank you for your guidance and best regards.
Mike

This is not currently possible. In most cases, failure of the primary solver and then subsequent failure of the backup solver means that SGPro cannot figure out where you are pointing. I do see the use case you are presenting though… it may be something we can add in to future versions. Thx.

Thank you!
Mike