Perhaps my workflow is slightly out, however, this is what happens when i start my sequence.
- Slew to target in CdC
- Calibrate PHD2 (in PHD2) & start guiding
- Solve and Sync in SGP
- Auto centre on target when sequence starts.
The sequence begins, and runs the auto centre routine, which validates the frame and succeeds. Then I notice "Waiting for auto guider to report status (force recalibration)" in the status bar. PHD2 re-runs its calibrate routine, and guides correctly. However, SGP fails with an error and aborts the sequence. So, I turn off Auto centre and just start capturing, ignoring the location data.
Is there something amiss with my workflow? I'm still figuring out all of SGP's features / integration with PHD2.