Can't Turn on Alnitak Flip Flat while Waiting for Sequence Start

Sequence Generator Equipment Compatibility
1

I have an Alnitak Flip Flat and seems to work fine during actual operation. I have a sequence waiting to start at 11:00 pm. The Flip Flat is connected and I can open and close it from the Control Panel but cannot turn on the illumination for test purposes. Is this expected behavior?

2

I have the same item and I can control the light with the slider fine without any sequences running, so it may be a driver or cable issue perhaps? It may be that as the sequence is essentially triggered but on a delayed start, this is preventing it operating?

I run 2.6.0.23.

3

Wayne,
If I recall correctly the flip flat needs to be in the closed position for it to illuminate. If you have it open and are toggling the light to test it may not illuminate. If you can post your SGP log I can also take a look.

Thanks,
Jared

4

Tried it again, it appears to work now. Thanks!