Did you follow the installation instructions as outlined by the read me file in the zip? Specifically, did you right click and install as administrator?
This error indicates that the Elbrus server failed to register with the operating system. What OS do you have? What folder did you attempt to install in?
You can try to:
Open Elbrus.exe manually. Sometimes this will force registration of the COM server.
Open a command prompt (terminal) as admin. Navigate to the folder you installed Elbrus (the folder that contains Elbrus.exe), then run:
Ok here’s what I’ve done …
Operating System Win 7 - Fully updated with patches
Installed as Administrator
Installed to C:\Elbrus
Installation seems Ok
Tried to do the Elbrus.exe /regserver
No errors from this command
Rebooted the computer
Same error…
Hmmm is right. No Elbrus does not work when I try to envoke it as a stand alone program… I don’t understand, as I had this working at one time…
I’m wondering if I should go up on the Yahoo board and download
the program from there …
Ok I got it to work finally, apparently the registration worked, but I had a
copy of elbrus running, when I killed that process and restarted it, everything
finally worked… Thanks for the help…
What happens when you double click Elbrus.exe? Have you tried going into the properties, checking the “Run as Administrator” option? Lastly, you may try the last option with your UAT settings turned off and see what happens.
I have found a problem with the plate solve routine when using an existing
image to plate solve. After inputting the angle and scale, it solves just
fine. However the next time I try it, instead of 359 Deg that was previously
input, it now shows 9 Degs. It will then fail with the RPC error that I had
before.