Filter nomination

I’m about to start using an 8 inch RASA with a filter draw for single filters and I want to be able to specify the filter I’m using as part of the filer name. With no filterwheel connected the only filter information is ‘none’ in the sequence drop down.
Is there a way I can specify a filter without a filter wheel. I want (if possible) to set a filter per event with a pause between events for filter change, focus etc…
Francis

I believe “Manual Filter Wheel” should get you what you need. :slight_smile:

Thanks - missed that in the drop down.

Hello, I also am doing the same with a RASA. I tried to use the Manual Filter wheel setup. I list the filters hit okay, go to the sequence and nothing is listed. Any suggestions. I tried youtube, have the book, before writing this.

Thanks g

Hi GaryQ, Welcome.
I currently add the filter name to the target ref, my target then is something like this for the single filters used with the RASA 8: M31_RASA_533_NB1
Which is: The subject (M31), The scope (RASA), the camera (533) and the filter (NB1)
Then if I change filters I change the target accordingly.

Ha!!! Never thought of that, thanks so much for responding. I’ll try that and keep at the other method mentioned.