Description
I had issues when cooling down the Moravian 16200.
SGP version 3.1.0.428
Windows 10
The cooler was not working properly. It was set to get to -20, but it was unable to get there (it reached -4 after very long time and manual attempts to set it to -20°C). The power was less than 10%.
I had to stop and reset the sequence and apply again the profile to the sequence. Now it woks. I hope it was my fault.
thanks
francesco
Link to Logs
Useful Info
OS: Microsoft Windows 10 Enterprise Ver: 3.1.0.428 .NET: 4.8
Ok. Well, there is nothing interesting in the logs. All of the commands SGPro sent seem correct. If it happens again, we will also need to see camera logs so we can determine where the error lies.
I just recieved my 16200 and I have the same issue. Does not reach temp -20. % of cooling never goes above 50. Open in SIPS set to -20 reaches temp in 5min.
Just to be clear SGP uses the ascom driver. Sips uses the native driver. Have you looked at the ascom camera settings?
I’ve been using a G3-16200 for several years without issue. Cools to - 40 below ambient in about 5min with SGP.