"Light frames found after park command" error

Sequence Generator
1

I got this error. How do you clear it? I could not restart the sequence.

Peter

2

I got this one too last night, for the first time. I had set up 50x 600sec subs. That would take way more time than I had darkness.

So I changed it to 30x 600sec subs. And the error went away.

Maybe my mount (Mach1GTO, GTOCP4, APCC) knows when I will hit the horizon and tells SGP “no can do”?

3

This is old behavior from before SGPro knew how to unpark and use a mount mid-sequence. It has been removed and will be in 3.1.0.453.

4

I got it again last night after pausing the sequence for a manual re-center. Any way to override it? All I could do was delete the target and re-enter all the settings on a new target. A pain!

Peter

5

As I mentioned above, version 3.1.0.453 or later will no longer pester you about this issue.

6

When will it be available?

In a message dated 2/25/2020 7:32:52 AM Pacific Standard Time, forums@mainsequencesoftware.com writes:

7

It is available now.

8

Can you send the link please?

In a message dated 2/25/2020 10:11:30 AM Pacific Standard Time, forums@mainsequencesoftware.com writes:

9

Help Menu -> Check for Updates