Limit of error of the Manual Rotation

Sequence Generator Request Archive
1

Hello,
Is possible to add a feature where if the manual rotation error of my camera is >x° I can skip the procedure and go on.
I mean last night I was framing and my error was 3°, so pretty close to the angle i was design before, but I cannot start framing until I disable the rotation check.
I’d like to have a function like the plate solving error where I can set a max error and then accept it.

I hope my request is clear.

Thank you,
Matteo Collina

PS: I love your software <3

2

Matteo,
I think this is what you’re looking for:

Thanks,
Jared

3

You right. I didn’t see this function on my control panel. :smiley:

Thank you very much,
Matteo Collina