Right… Avoiding a pier crash is the point of this thread.
Attached is another log, I changed drivers to see if there’s a difference. This driver is newer but poorly coded. It hammers CPU but seemed ok until a moment ago when it threw up a mount isn’t tracking yes/no dialog. If i could set that dialog to auto continue (choose yes) then i would probably over come this.
The mount was tracking and PHD2 was running perfectly with total RMS 0,6(.55’). this wasn’t a meridian flip but just after a plate solve. Youll see the event at [05/15/17 00:43:01.506] I clicked yes and the sequence continued without further issue. Had i not been awake, this was a night ending event.
thanks,sg_logfile_20170514204214 (2).zip (128.7 KB)