Patesolve 2 lost; how can I SGP the position of the scope with the blind solver?

Sequence Generator Plate Solving
1

I have ran into this situation a couple of times on the first slew.
The scope is not near enough for Platesolve2 to platesolve. I then resort to the blind solver to find where the scope is pointing. The blind solver does its job and reports the coordinates back on the screen.

How do I use those coordinates to tell SGP where the scope is actually pointing?

2

If you are doing a “Solve and sync” then when the solve is successful it
will tell the mount where it is pointing.

1 Like
3

Thanks, I’ll try that.