Plate Solving Error message

Sequence Generator
1

I am a new user of SPG. I created a sequence with Framing and Focus Wizard.

When I tried to Run the Sequence I got the following Message:

Error message:
The sequence requires the use of a plate solver, but none are selected. Please select one in the control panel’s “Plant Solve” tab and try again. -At least one target will attempt to automatically center.

Seq%201
Seq 1.png1920×1080 462 KB

Equipment Profile

Seq%202
Seq 2.png1920×1080 536 KB

Plate Solve Tab

Seq%203
Seq 3.png1920×1080 524 KB

2

Check if your sequence has it, you may have set it up in the equipment profile but the sequence doesn’t have it. Think of the EQ profile like a template. If you make a new sequence it should then have those settings.

Check the ‘control panel’ which affects the current sequence. Ctrl+E