Plate Solving Error message

I am a new user of SPG. I created a sequence with Framing and Focus Wizard.

When I tried to Run the Sequence I got the following Message:

Error message:
The sequence requires the use of a plate solver, but none are selected. Please select one in the control panel’s “Plant Solve” tab and try again. -At least one target will attempt to automatically center.

Equipment Profile

Plate Solve Tab

Check if your sequence has it, you may have set it up in the equipment profile but the sequence doesn’t have it. Think of the EQ profile like a template. If you make a new sequence it should then have those settings.

Check the ‘control panel’ which affects the current sequence. Ctrl+E

www.mainsequencesoftware.com