Fixed the problem. Reconnected serial cables and resolved the problem.
I can connect to SGP.
Introduced another problem, I cannot run both SGP and SkyX at the same time, says there is a porting sharing problem.
Is this an Ioptron Ascom driver problem, or is not possible.
Continuing the discussion from
Cannot connect Ioptron CEM60 to SGPro:
I cannot connect SGP to the CEM60 mount. I have the latest firmware and ASCOM 4 driver installed. I have SGP 184.108.40.206 installed. Interesting, I have SkyX and can connect to that program, so the serial cable connection is good.
This is my first post and I am a newbie. I have searched the forum for members with similar problems, and found members who apparently have no problems with connecting to the mount, but had other issues, side of pier, etc.
I am running on Windows 7 SP1. Below is part of the log file which is probably the most relavent section. Also received an error message, error connecting to Ioptron ASCOM driver.
I have sent an email to Ioptron support, but no reply yet. I would appreciate any input that might help.
[5/7/2015 11:45:18 AM] [DEBUG] [Telescope Thread] Telescope Dispatch loop: Received SGM_TELESCOPE_CONNECT…
[5/7/2015 11:45:49 AM] [DEBUG] [Main Thread] Error connecting to telescope. Timed out.