Problem starting a sequence


#1

hi, can i just check this out to see where I’m going astray. I set up a sequence - now with framing and mosaic wizard which is a huge asset and i highly recommend it, I start the seq and the autofocus runs. Immediately following the autofocus run, the sequence reports it’s complete (no exposures taken) the end of seq dialog appears and I dismiss that.

Any help appreciated.
thanks
Paul


#2

There could be lots of reasons for this. The log would be helpful. Are you sure that the target was selected, and that the events were selected in the sequencer window?


www.mainsequencesoftware.com