Weather station properties error


#1

Using the 2.4 beta and getting the following error, when I push the properties button (after connecting and disconnect the weather station):

After clicking OK and trying the connect I’m getting following message:

I have to close SGP and start again to connect or access the properties again.


#2

I’m seeing something slightly different, I select one of the Boltwood monitors, click on Connect, then click on Disconnect, then click on Connect again and get the message:

Connection Error
Error connecting to ASCOM Boltwood OK to Image!
Check Driver: cannot create object type of progID:
OK

If I reselect the device (the same one is fine) then connect works again.


#3

Hi guys,
Thanks for the screenshots which are helpful. It’s also helpful to include the log file for Ken and Jared to look at.


#4

Here’s a log file, Just start SGP, select safety, connect, disconnect, connect, clear error, select safety, connect, close.
sg_logfile_20141217160350.zip (2.5 KB)
The connection failure is between 16:04:14 and 16:04:22, that’s when I try to connect, get the message, clear it and reselect the device.


#5

I’m seeing this too. I think some of the connect/disconnect logic didn’t get fully implemented. I’ll take a look and get this addressed in the next beta.

Thanks,
Jared


www.mainsequencesoftware.com