When using the Frame and mosaic Wizard everything works fine except I never get prompted to rotate the camera. After centering it says rotation error is n/a. I have to go to target settings and right click rotate and go through the rotation only centering routine to get an idea where my camera should be in coordination with the FMWizard. The documentation says I should be prompted but for me only when ran separate from centering.
In Target settings under the sub heading ‘other’ I have rotation checked. The degrees are displayed correctly in what I have for FMWizard. I’m out imaging now just never got prompted. Unless I’m in the wrong menu?
You will not be prompted to rotate the camera if you are already within tolerance. Sounds like you ran it manually prior to starting the sequence. Is that what’s happening?
I ran it manually to start the sequence to get the framing I wanted, but I was 158 degrees off initially. The centering tolerance is set to 1 degree. I do hear a Windows ‘ding’ a few times during the centering and rotation routine. Is it possible there is an error somewhere? I don’t see any dialogs pop up.
I don’t have the internet where I’m imaging and cell service is spotty. I will try and look through and send the logs tomorrow. Thanks for the quick responses.
Great, thanks for taking a look. Great support with this program. I was queing the centering task manually from the menu instead of letting SGP run things. Which it does wonderfully.