I think I'm again, missing the boat on this one. The camera works fine. It's
I have totally ignored the plate solve set up when using the Mosaic Wizard.
I think I should set the exposure to
10 seconds and binning to 2 X 2? Something I'm doing wrong in Plate Solving
setup. Forget the Mosaic Wizard
for the moment. When doing my sequences before I started using the Mosaic
Wizard for the first time, all my images
turn out great. It took me a while to get it right on using the Flats
Wizard. Now it's a problem with Me and the Mosaic Wizard.
I've looked on the web for a tutorial but have only seen a 5 minute tutorial
on the Mosaic Wizard.
I am fine right to the point of selecting my image, framing it, and applying
the Equipment Profile to the sequence. I to to the
Sequence, then open up the Target Settings, and see that the fields (RA &
Dec) have been populated correctly.
Then I click CENTER ON and the plate solving starts....This is where it
screws up and gives me a failure notice. So there must
be something in the Plate Solve set up that I'm doing wrong....is this
correct? Thanks again Ken