3.02.94 won't start!

Sequence Generator
1

I have been using 3.02.91 very happily, until suddenly no images are being fetched in frames&mosaic.
So I can’t creae a target anymore.
Updated to 3.02.94 as advised.
Now SGP does not start anymore!!!
I see the rotating circle for a few seconds and then this disappears too.’
What is going here?
I like this software. But it should work.
All the previous versions ran OK on this PC.
Finally some clear skies and I am not happy…

Uninstalled, re-installed, ran as administrator, emptied the profiles directory. Nothing.
Re-installed 3.02.91 and this cripled version runs again, but no image fetching.

2

You can try following the steps here:
http://mainsequencesoftware.com/Content/SGPHelp/SGProWontStart.html

Thank you,
Jared

3

Hi Jared,

I tried both.

/recover and /reset have no effect.

No starting of SGP.

91 installs and runs ok, but has the known problem of not fetching images.

Uninstalling with crapcleaner, removing the remaining directory.

Do a clean install of 94.

No start of SGP.

/recover and /reset have no effect.

94 has not started ever.

Re-install 91

Runs.

Still unable to run 94

Regards

Arie

4

I got it running!
This is what I did:

I did not uninstall .91
Made a new directory SGP2 in programfiles(x86)
Ran the installer and directed the installation to this new direcory.
Done!
It started straight away and found the profiles and targets and all the other good stuff.
Now I don’t really know what to do with the old directory where 91 still sits.
I renamed it to SequencegeneratorOLD. And .94 still runs fine.
Strange, strange behavior.
In previous attempts I had .91 completely removed, including the seq.gen.pro directory and did a clean install. That did not help.
.94 starts fast and seems to be running fine, including fetching canvas images again.

Arie