I don’t understand the Flat Wizard. The text implies it is making flats from lights which seems impossible.
marshall edgell
Flats are light frames.
But the ‘type’ needs to be set to “Flat”.
I have done a flat calibration wizard and the values for each filter have been saved correctly.
But when I run flats wizard an event is created without the saved exposure time values. The exposure time does not appear if I create a flats event either.
I don’t know what can happen!
Where did you save the results of the flat wizard to? If you saved them to your Equipment Profile then you’ll need to apply that profile to your current sequence or make a sequence with that profile. If you saved them to your current sequence then they’re only applicable to that sequence.
Jared
OK, thanks!