Sorry I though I would bring this up again as I thought I had sorted it with the tick boxes but it looks like I haven't
I was imaging last night and knew the object would go past the meridian and waited for it to happen but it didn't although tick boxes were checked as far as I know. I'm not sure what I'm missing or doing wrong.
I'm using t5rhe Sky6 pro for my goto's via eqdir/eqmod on a eq6 Pro mount.
In SGP the Auto Meridian flip box was checked, but at the time the object passed the meridian it was halfway through an exposure. So I went out to watch it flip after that exposure, but the next exposure just started without the flip. What I have noticed in SGP when the check box for "Use Auto Meridian Flip" is enabled, under the controls the "TimeTo" either merdian or flip states N/A, but unchecked it gives the countdown to either Merdian or flip ( Sorry cannot remember what one). The "SET" was clickable but the "RUN" wasn't.....
What I had to do was pause the sequence and use the Sky6 to slew to the same object so it done a "Flip" then restart the sequence, Once re-starting and it re plate solving I get a error saying that it cannot perform the meridian flip !!!!!
Once I got it sorted the "RUN" box was clickable but it's wasn't needed as I had used the planetarium to slew.
any way I got around the and started imaging again but why cannot I execute a auto meridian flip ???