Hello to everyone,
ii’m planning to motorize my rolloffroof with an IPX800 Ethernet relay controller: Web relay board ipx800 v3
An ASCOM driver is available in various flavour:
http://www.elendil.software/en/softwares/ipx800-roll-off-roof.html
http://www.elendil.software/en/softwares/ipx800-switch.html
But after installed it’s not available on Observatory control. Could it be supported?
ASCOM is well made and allows to open/close rolloffroof with some security hints.
Hi Andrea,
If you install the first driver you mentioned ( http://www.elendil.software/en/softwares/ipx800-roll-off-roof.html ) it should appears in the available ASCOM Dome drivers. There should nothing more to do.
Regards
Julien
www.elendil.software
Hello Julien,
Thanks for prompt reply. A couple oggetto minutes ago i noticed i installed
the switch Ascom driver.
Once replaced with RollOffRoof driver everything was fine
Thanks
Andrea
Ok. Let me know if you need more help for the driver configuration.
Julien