Why is Auto Center Exposure 60 Seconds?

Sequence Generator
1

After Recovery and SGP begins an auto center operation, it uses an exposure of 60 seconds. Is this a parameter set somewhere that is unique to Recovery? Can I change it? I do not use 60 seconds for my auto centering operation, and the only time I see this exposure length for auto centering is after Recovery.

2

It should be using the settings in your plate solver. I’ll check if that’s the case.

Thanks,
Jared

3

Hi Jared,
Have you had a chance to look at this? In my profile, the SolverExposure is set to 30 seconds. Where is the Recovery getting 60 seconds for the exposure to use to auto center, and can it be adjusted to be 30 seconds?

Thank you,
Manning